Frequently asked questions

CRM does not switch on.

CRM can not be charged.

The DMA35N can not be used.

CRM does not switch on:

The CRM does need about 7-10 seconds to switch on.

CRM can not be charged:

If the charger signals only a red blinking LED, than the CRM could not have been powered down correctly. The charger can not supply enough current to charge and run the CRM simultaneously. In such a case you do have to take a second battery pack (or replace the empty batteries with charged ones) to power on the CRM. After the CRM has been powered on switch off the unit correctly. Replace the second battery pack with the one you wish to charge. Plug in the charger, the charging process should start now. Please be careful when using non rechargeable batteries for powering on the device. Be sure to remove and replace them before charging!

The DMA35N can not be used:

The DMA35N interface will be programmed soon. Be sure that you have ordered the CRM-DMA interface cable for proper interfacing.